Patch1 Edge detection for Lotem 400 version 1.60.09 has been released to resolve the following issues:

Edge detection among the factors that lead to edge detection problems were the following: 

The location and width of strips 1 and 2 were not precise. 
The System was sensitive to inconsistancies in the power supply. 
Support for MCF2 board, comp level R and earlier.
Windows error message during shutdown in the Lotem 400 Xpose with UDRC configuration.
 
Pre Requisite: Before loading the patch, if you have made any mechanical changes to the pins, spoilers, or encoders, recalibrate the 'Width Start Image Area'.
